Settings for Nozzle timing? http://makerbot.wikidot.com/forum/t-610061/settings-for-nozzle-timing Posts in the discussion thread "Settings for Nozzle timing?" - Looking for the setting dealing with the timing of turning on the nozzle during times of travel. Sun, 07 Jun 2026 13:52:47 +0000 http://makerbot.wikidot.com/forum/t-610061#post-2341626 Re: Settings for Nozzle timing? http://makerbot.wikidot.com/forum/t-610061/settings-for-nozzle-timing#post-2341626 Mon, 20 Jul 2015 09:44:54 +0000 FaridGharavi 2214552 not a clue

]]> http://makerbot.wikidot.com/forum/t-610061#post-1672558 Settings for Nozzle timing? http://makerbot.wikidot.com/forum/t-610061/settings-for-nozzle-timing#post-1672558 Fri, 28 Dec 2012 19:11:08 +0000 adam1mc 685305 Setup: Cupcake, MK6, Gen-3, 3G Shield Hack, HBP

My current print has larger periods of travel in order to build tall pilers on the corners of the object. During the time of travel from one corner of the object to the other, the nozzle starts to extrude 1-2 seconds before arriving to the corner. As a result, each of the pilers has little excess lines of plastic hanging from the sides. I'll have to go in and trim it to clean it up.

Is there a setting that deals with this in SF? Some setting that will prevent the nozzle from turning on too soon before arriving to the destination of where it should start extruding?

]]>