Printing problems and solutions . . . .
Hallo,
Being new to the makerbot and reprap, theres a few things im really not sure about. Firstly, I have problems during printing which im sure is skeinforges fault (settings etc) attemoting to read through the documentation and it really isnt very friendly to non-experts in it. Is there a primer out there whith examples and fixes? i.e. Im getting blobs at the start of printing and it isnt starting at the right time. Ive tried a couple of settings, but it doesnt seem to make much sense. Is there a guide to setting the settings for when you first start printing?
As always, any help is much appreciated! Oh, and I would like to acheive the same print reolution as Nophead in the hydraraptor. Is this possible with the makerbot?