Dead extruder board - no LEDs
Forum » MakerBot Forums / Talk about MakerBot » Dead extruder board - no LEDs
Started by: jdesengjdeseng
Date: 23 Apr 2010 14:42
Number of posts: 11
rss icon RSS: New posts
Summary:
It was working for about an hour. Now the only way I can get the motherboard to start up is to unplug the ethernet cable from the extruder board and cycle the power. If I plug in the ethernet cable the motherboard kicks off the power supply and the red debug light flashes.
New Post
Unless otherwise stated, the content of this page is licensed under GNU Free Documentation License.