I recently discovered Makerware (havaing previously been using ReplicatorG) and thought I'd give it a try and during the process also discovered that the Replicator firmware was now at v5.6 and I had v5.5.
So I upgraded the firmware on the Replicator too.
I started to see some problems and have some queries, so I thought I'd search the Makerbot pages/forums etc looking for answers, but I can't find anything about v5.6 - it's as if I am the only one who has upgraded. Hasn't anyone else noticed the lights don't necessarily go on inside the machine (although this morning, for some odd reason, they have)?
Hasn't anyone else (other than Michael Aboltins) found that prints from the left extruder are shifted 3cms to the right and so bits can fall off the print bed?
Is there anywhere I can go for hints, tips or even to read others' feedback on Makerware?
Andy