Settings for Nozzle timing?
Setup: Cupcake, MK6, Gen-3, 3G Shield Hack, HBP
My current print has larger periods of travel in order to build tall pilers on the corners of the object. During the time of travel from one corner of the object to the other, the nozzle starts to extrude 1-2 seconds before arriving to the corner. As a result, each of the pilers has little excess lines of plastic hanging from the sides. I'll have to go in and trim it to clean it up.
Is there a setting that deals with this in SF? Some setting that will prevent the nozzle from turning on too soon before arriving to the destination of where it should start extruding?